Genicom 3600 Manuel d'utilisateur télécharger pdf (Page 67)

c39 frank

Testing and Adjusting

3-23

6. When the tool fits properly on all of the rollers and the bushing, tighten the

screws on the outboard plate that you are aligning.

7. Reattach the front bezel cover. Ensure that the media access door operates

properly (snaps firmly shut) after the front bezel cover is installed.

8. Install the electronics cover.

9. Reload media (and ribbon if used).

10. Install the media cover and the power cord.

11. Switch on printer power and check for proper operation.

Aligning the Printhead

Align the printhead only if necessary. To perform this procedure, you need the

following tools:

• Printhead alignment tool, Intermec Part No. T43099

• 9/64-inch Allen screwdriver

To align the printhead

1. Switch off the printer power. Remove the power cord and the media cover.

2. Raise the printhead with the printhead lift lever. Remove media and ribbon.

3. Position the printhead adjustment lever clockwise/left two clicks during

the printhead alignment. Loosen the two Allen screws located on the

printhead yoke at the back of the printhead heatsink.

1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8

3600M.039

moves printhead

backward

Printhead

adjustment

lever

moves printhead

forward

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 173 174

Pas de commentaire

Genicom 3600 Manuel d'utilisateur Page 67